Perfect_Heart_Shape

Michael Tyler at CarveBuddy.com put together this heart drawing tutorial that is so simple it’s brilliant. Check it out!

Source: Draw the “no-brainer” Perfect Heart Shape! | CarveBuddy

Draw the “no-brainer” Perfect Heart Shape!

A question was posted on the CarveWright User Forum asking how to create a simple closed heart shape. Several answers were suggested and would work. However, there is a much simpler solution that was missed, which I’ll offer here…

You can create a perfect heart shape easily and quickly, using the procedure outlined below. The step-by-step instructions and screenshots are specific to the CarveWright Designer software, but this same basic method can be employed in practically any similar CAD/CAM software (ArtCAM, Vectric Aspire or Vectric VCarve Pro, for example).

Look at the screenshot photos as a guide while following the steps below…

STEP 1
In CarveWright Designer, draw a closed square shape manually at a 45-degree angle using the Connected Line Tool and with the Snap to Grid turned ON to make it easier to draw your square. (In some software, you can just draw a square and rotate the square around its center by 45 degrees.)

draw_a_45-degree-angled_square


 

STEP 2

Right-click on each of the top two line segments and change each straight line segment to an Arc. If the Arc flips the wrong way (inside instead of out), just right click again and select Reverse Arc (or you can just drag the center arc point manually and snap to the grid)

change_straight_lines_to_Arcs


STEP 3

Admire your result – a perfect closed Heart Shape in about 10 seconds!

After creating your “perfect heart” you can opt to change the vector forms of the line segments to curves to have full and complete ability to alter the shape further in any way you wish.

Perfect_Heart_Shape-1

See more at CarveBuddy.com

 

2 thoughts on “Draw the “no-brainer” Perfect Heart Shape! | CarveBuddy

  1. What a great idea so close to Valentine Day. Did a doubledown, added a grandchilds name with Confomring ext and cut it out. Used some cherry pieces and finished with tung oil. Turned out beautiful. Thanks a bunch.

Leave a Reply

Your email address will not be published. Required fields are marked *

Please type the characters of this captcha image in the input box

Please type the characters of this captcha image in the input box