#################################################### # # # Welcome to the Pattern Sculptor # # # #################################################### Sections: I. Introduction and Help II. Release Notes ### (I) Introduction and Help ###################### Thank you for installing the Pattern Sculptor by CarveWright. After installing the software you will be unable to save your work until you've licensed the software. A licenese will be required for each computer you wish to use the software on. To obtain a license: Sculptor must be registered in order to fully utilize the software. A license can be purchased from http://www.carvewright.com Licensing Instructions can be found here: http://www.carvewright.com/assets/service/Manuals/Pattern_Sculptor_Installation.pdf If you need assistance, please feel free to contact us. Our goal is to create the best possible product. LHR Technologies, Inc. 4930 Allen Genoa Rd., Suite D Pasadena, TX 77504 Tel. +1 713 473-6572 http://www.carvewright.com email support@carvewright.com ### (IV) Release Notes ############################ 15 Dec 2014 Differences between versions 1.001 and 1.00 * Fixed a bug where the Z Scale control wasn't updated when an scp file was loaded. Touching the control would reset z scale to the control's value. * Corrected inconsistent limits for tool size and strength that varied depending on if the arrow key, the mouse wheel or the slider was used. * Fixed filtering of arrow keys so they work normally when focus is in the zScale spin box. * Now explicitly enable the tools when an scp file is loaded, and explicitly disable them when any import file type is loaded. Previously the user might have had to change to another tab and back again to get the tools enabled. * Added bas-relief contrast enhancement to the import panel. * Save no longer prompts for the file name unless the file doesn't exist yet. * Added SaveAs to the main menu. * Changed file extension behavior when saving. Previously, if no extension was specified the correct extension was appended, but otherwise the filename was used as given. Now if the specified extension is different than the correct extension, or is empty, the correct extension is appended. For example: sample becomes sample.scp and sample.xxx becomes sample.xxx.scp 15 Oct 2014 Initiall Release Version 1.000